Page of
7
14
6. Install a grommet on bottom of the enclosure using the preformed divot as a guide for the drill bit. See
lower diagram.
7. Drill the mounting holes into the mounting surface.
a. If using wall anchors: Following the hole pattern shown above, use an appropriate 3/16-inch drill
bit to drill holes into the surface with a depth of at least 1.25 inches. Place the wall anchors
into the newly drilled holes.
b. If NOT using wall anchors: Following the hole pattern shown above, use a 7/64-inch drill bit to drill
holes into the surface with a depth of at least 1.25 inches.
8. Use a Phillips screwdriver to mount the enclosure to the surface using the four #8 x 1 inch screws
included with the enclosure. See diagram on page 8.
9. Use a Phillips screwdriver to mount the backplate and circuit boards in the enclosure.
10. Enclosure locking screws (6-32 x 3/8) max torque rating 8.5 inch-pounds.
2.99
1.55
8.15
4.65
1.90
.70
1.45
.95
All dimensions shown are in inches.
