CY8CPROTO-062S3-4343W PSoC 62S3 Wi-Fi BT Prototyping Kit Guide, Doc. # 002-28070 Rev. *A
8
1.
Introduction
Thank you for your interest in the CY8CPROTO-062S3-4343W PSoC 62S3 Wi-Fi BT Prototyping Kit
(hereafter called PSoC 62S3 Wi-Fi BT Kit). The PSoC 62S3 Wi-Fi BT Kit enables you to evaluate
and develop your applications using the
(hereafter called “PSoC 6 MCU”) and
CYW4343W WICED Wi-Fi/BT combo device.
PSoC 6 MCU is Cypress’ latest, ultra-low-power PSoC specifically designed for wearables and IoT
products. PSoC 6 MCU is a true programmable embedded system-on-chip, integrating a 150-MHz
ARM
®
Cortex
®
-M4 as the primary application processor, a 100-MHz ARM Cortex
®
-M0+ that
supports low-power operations, up to 2 MB Flash and 1 MB SRAM, Secure Digital Host Controller
(SDHC) supporting SD/SDIO/eMMC interfaces, CapSense
®
touch-sensing, and programmable
analog and digital peripherals that allow higher flexibility, in-field tuning of the design, and faster
time-to-market.
The PSoC 6 MCU on this kit has 512 KB of Flash and 256 KB of SRAM.
The PSoC 62S3 Wi-Fi BT Kit carries a PSoC 6 MCU and a CYW4343W based Wi-Fi and Bluetooth
combination module. In addition, the board features an onboard programmer/debugger (KitProg3), a
512-MB Quad SPI NOR flash, a Micro-B connector for USB device interface, a 5-segment
CapSense slider, two CapSense buttons, a user LED, and one push button. The board supports
operating voltages from 1.8 V to 3.3 V for PSoC 6 MCU.
You can use ModusToolbox™ to develop and debug your PSoC 6 MCU projects.
is a set of tools that enable you to integrate Cypress devices into your existing development
methodology. Application development using PSoC 62S3 Wi-Fi BT Kit is also supported in other
development environments such as Mbed OS.
If you are new to PSoC 6 MCU and ModusToolbox IDE, refer to the application note
Getting Started with PSoC 6 MCU
to help you familiarize with the PSoC 6 MCU and help you create
your own design using the ModusToolbox IDE.
