© 2012 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks
referenced herein are the properties of their respective owners. Doc.#: 001-80792 Rev. **
http://www.cypress.com/go/CY8CKIT-016
For the latest information about this kit, visit
CY8CKIT-016 PS
O
C
®
1 THERMAL MANAGEMENT KIT
QUICK START GUIDE
Connect VR to P0_7 and SW1 to P1_7on the
CY8CKIT-001; set J11 with a jumper.
Plug the CY8C28 family processor module
into CY8CKIT-001.
On the CY8CKIT-036, set jumpers as follows:
J2 to SINGLE, J3 to 3.3 V, and J9 to 12V_DVK.
Connect the MiniProg3 to the CY8C28 family
processor module.
Launch PSoC Programmer; load
CY8CKIT_016_Example_Project.hex
, located at
C:\Program Files\Cypress\CY8CKIT-016\1.0\
Firmware\Hex_File.
In PSoC Programmer, use the following settings:
Programming Mode:
Power Cycle
, Auto Detection:
ON
, Protocol:
ISSP
, Voltage:
5.0
.
Click on
Program
to program the device.
After programming, remove MiniProg3 and
insert the CY8CKIT-036 into Port A of the
CY8CKIT-001; power the CY8CKIT-001.
The LCD will display Zone 1 temperature, set
fan speed, and actual fan speed
Pressing SW1 will display the same for Zone 2.
Pressing SW1 again will display Zone tempera-
ture and individual temperature sensor readings.
See the example project in the kit guide for
details.
3
4
5
6
