CY6611 EZ-USB HX3PD Evaluation Kit Guide, Document Number: 002-26068 Rev *A
19
4
Kit Operation
This chapter describes the procedure to demonstrate the USB 3.1 Gen 2 Hub (10 Gbps), PD 3.0 and Battery Charging (BC 1.2)
features supported by the CY6611 EVK. See
for the contents of the kit and
for
additional hardware required to demonstrate these features.
It is recommended that you read this guide in the order that the sections are presented.
4.1 Pre-requisites
The following items are needed to perform the kit operations:
Items provided with the kit:
19-V, 65.2-W AC/DC power adapter
CY6611 EVK board
USB Full-Featured Type-C Cable
Items not provided with the kit:
Laptop with USB 3.1 Gen 2 (10 Gbps) and USB PD support
USB 3.1 Gen 2 (10 Gbps) Solid State Drives (SSD)
USB 2.0 flash drives
Multimeter
4.2 Powering CY6611 EVK
Follow these steps to power the CY6611 EVK:
1. Unpack the kit package and check the kit contents.
2. Verify that jumpers are installed at J2, J6, and J10 as shown in
3. Connect the power adapter provided with the kit to the DC Power Jack (J12) of the CY6611 EVK board. Plug the other end
of the power adapter into an AC power socket.
4. Power LEDs (LED3 - LED5) glow green to indicate that the kit is powered. Also, the PD CTRLR LED and DMC LED blink
green to indicate that the firmware is running and the kit is ready for operation.