Cypress CY4500 EZ-PD, Manual, Page: 14 / 19

Analyzer Operation
CY4500 EZ-
PD™ Protocol Analyzer Guide, Doc. No. 002-12170 Rev. **
14
Figure 4-2: EZ-PD Analyzer Utility Start-up Page
5. Click on the Start Capturing icon . Alternatively, you can start capturing data by clicking on Actions > Start
Capturing from the menu bar. The status bar at the bottom of the utility window shows the message
“EZ-PD
Analyzer is running
” (similar to the status bar at the bottom of
Figure 4-4 ).
6. Connect a USB Type-C power adapter (not provided with the analyzer) to the USB Type-C receptacle (Connector
J2) of the CY4500 EZ-
PD™ Protocol Analyzer board. Verify that your setup looks similar to the image shown in
Figure 4-3 . The USB Type-C power adapter mentioned here is just an example. Any USB Type-C device can be
used in its place.
Figure 4-3: Completing the Setup for Operating CY4500 EZ-
PD™ Protocol Analyzer