The CY3250-PLC20NQ emulation POD is designed to work with the PSoC
®
ICE
Cube (In-Circuit Emulator). The ICE Cube can be purchased separately as a part of
the CY3215-DK kit available from the Cypress Online Store at
Getting Started
:
1.
Solder one of the included emulation POD feet to your target board in place of
the Cypress CY8CPLC20 part.
2.
Connect the larger end of the CY3250-FLEXCABLE to the ICE Cube emulator.
Ensure that power is being supplied to the ICE Cube. Also, ensure that the ICE
Cube is connected to your host PC via a USB cable provided with the CY3215-
DK In-Circuit Emulator Debugging Kit.
3.
Connect the smaller end of the CY3250-FLEXCABLE to the POD as shown on
the front side of this card.
4.
Secure the flex cable to the POD using the included compression plate and red
thumb screws.
5.
Connect the POD to the foot previously soldered to your target board, making
sure the pins align correctly using the pin 1 indicators on the POD and foot.
6.
Open the PSoC Designer application
A
, which is included on CD as part of the
CY3215-DK kit, and create a firmware project using the appropriate device.
7.
To begin debugging your firmware project, follow the instructions within the
PSoC Designer application
.
For more information about the CY8CPLC20 device, visit us at
There you will find datasheets and application notes. For application support, visit us
at
.
A.
Update to the latest PSoC Designer™ including service pack releases at:
http://www.cypress.com/psocdesigner
POD
Thumb 1
Compression Plate
Flex cable
Feet Mask
© Cypress Semiconductor Corporation, 2009. All rights reserved. PSoC is a registered
trademark and PSoC Designer™ is a trademark of Cypress Semiconductor Corp. All
other trademarks or registered trademarks referenced herein are the property of their
respective owners. The information contained herein is subject to change without
notice. Printed in the U.S.A.
Doc. # 001-54216 Rev. *A
