9
LDC-NA3S NA-3 WIRE FEEDER CONTROLS, CONT’D.
NOTE:
For further information refer to Lincoln Electric NA-3 Operator’s Manual.
A. AMMETER
Indicates current only while welding.
B. CIRCUIT BREAKER
Protects the circuit from sever wire feed motor overload and short circuits. Press to reset.
Locate and correct the cause for overload.
C. VOLTMETER (Standard)
Indicated welding voltage only while welding. Also indicates OCV below 60 volts.
D. START
Push-button beings the welding cycle
E. STOP
Push-button initiated the stopping cycle at the end of the weld.
F. INCH UP & INCH DOWN
Press to inch electrode at the speed set by “Inch Speed” control on inner panel.
G. CURRENT CONTROL
Adjusts wire feed speed to control welding current.
H. TRAVEL
Turn to “Off” for no travel; “Hand Travel” for travel without welding; “Automatic Travel” for
welding operations. Speed and direction of travel are controlled by the travel mechanisms
control.
I. VOLTAGE CONTROL
Adjust arc volts by controlling power source output voltage.
J. CONTROL POWER
Turns input control power “On” and “Off”. Also used as an emergency “Off” in case of
malfunction.
*For further information on NA-3 Wire Feeder and controls, refer to Lincoln Electric NA-3
Wire Feeder Operators Manual.
