3.
TV/CATV-
Press the button to select either aerial channel or cable channel.
4.
Display-
Press the button to turn on or off OSD display of input source on the
screen.
5.
Mute-
Press the button to mute the audio.
6.
Sleep-
Press the button to set a predetermined time (10-120 minutes) for
automatically turning off the machine.
7.
MTS-
Press the button to choose stereo, SAP or mono audio.
8.
PAL 50/60-
When video input is PAL system, depending on your selection the
unit will ether convert vertical frequency of PAL input from 50 Hz to 60 Hz or
just let 50 Hz pass through.
It is recommended that you select PAL 50, which is the factory default value,
which simply bypasses the vertical frequency to the output to obtain the best
picture quality. However, in some cases, the LCD monitor can not accept 50 Hz
vertical frequency, you have to press the button to select PAL 60 which converts
50 Hz input to 60 HZ so that the LCD monitor can lock into the frequency and
display the picture.
9.
VGA/YPbPr-
Press this button to select either VGA or YPbPr as output mode.
10.
CH – and +-
Press the up and down buttons to increase or decrease the channel
number.
11.
Recall-
Press this button to recall the last channel that was selected.
12.
Volume – and +-
Press the up and down buttons to increase or decrease the audio
volume.
13.
0 ~ 9-
Press this button to select desired TV/CATV channel directly.
14.
Menu/Enter-
Press the button to enter into OSD menu.
15.
Exit-
Press the button to exit OSD.
16.
“– and +”-
Press this button to move up or down the highlight bar of the
selected parameter.
17.
– And +-
Press this button to adjust the setting value of the selected parameter.
Installation
Power up the unit:
1. Plug the power jack into the power socket on the back of the unit, the power LED
will illuminate in red colour (Standby mode).
2. Press the power button, power LED will turn into a green light.
3. Press the power button again and it will return to standby mode.
4. When the unit is first powered up the default input to the unit is TV (RF) input.
When you have changed the input source and later power down the unit, the last
input source that you selected will be memorized by the unit. When you re-power
the unit the memorized input will be recalled as input source.
Please browse our online catalogue to view our full product range.
44-48 Maitland Road, Mayfield East, NSW, 2304 Australia,
Phone +61 249689313 Fax +61 249689314
www.converters.tv
