12
CY3240-I2USB I2C-USB Bridge Guide, Doc. # 001-66660 Rev.**
Getting Started
2.3
PSoC Programmer
To open PSoC Programmer, click
Start
>
Programs
>
Cypress
>
PSoC Programmer 3.12
>
PSoC Programmer 3.12
.
To successfully program the device, follow these steps:
1. Select the I2C-USB bridge in
Port Selection
, as shown in
Figure 2-8
.
Figure 2-8. PSoC Programmer Window
2. Click the
File Load
button to load the hex file.
3. Click the
Program
button to program the hex file on the chip.
4. Close PSoC Programmer.
2.4
Bridge Control Panel
The Bridge Control Panel is used with CY3240 I2C-USB Bridge to enable communication with I2C
slave devices. This program is used to configure I
2
C devices and also to acquire and process data
received from I2C slave devices. The Bridge Control Panel helps in optimizing, debugging, and cali-
brating the target application.
1. Click
Start > Programs > Cypress > Bridge Control Panel 1.2 > Bridge Control Panel
2. Select
Power Supply
, as highlighted in
Figure 2-9
.
3. Select the port connectivity.
[+] Feedback
electronic components distributor
