CYP QU-8MS, Operation Manual

Page: 9 / 44

9
6.2 Rear Panel
2 1 3
1 EDID switch STD/TV: This switch allows the user to choose the EDID
settings, the device must be turned on then off in order to make these
changes take effect. By switching to TV the device will read the EDID
of HDMI output 1 and will record it, then it will have the source send
the signal to the other seven HDMI outputs. The default setting is TV
which supports 3D content, leave as is when the display is working
properly. By switching to STD the device will use the built-in EDID,
which is set at 1080p@60/12bits for video and LPCM 2Ch for audio, to
allow the source to send a signal to the connected displays.
2 HDMI OUT 2~6 : Using HDMI cables connect these slots to displays in
order to show HDMI/3D content.
Note: When the input signal contains 3D data the display must also have
3D support in order to receive the signal.
3 SYS Reset ON/OFF: This switch allows the user to perform a system
reset. The default setting is OFF, leave as is when in normal use. By
switching ON, the unit will perform a reset every 8~10 minutes, in
order to perform this function the displays must have CEC support.
When performed successfully, the system will automatically switch the
displays to HDMI 1 input. The system reset will not perform on those
displays that do not have a CEC function.