8
6.2 Rear Panel
HDMI OUT
ON OFF
SYS.RESET
HDMI IN
1
2
3
4
5
6
7
8
9
10
SERVICE
DC 5V
STD TV
EDID
1
2
3 4 5
6
1
HDMI IN: Connect to HDMI equipped source equipment such as a Blu-
ray player, games console, Set-top Box or any HDMI equipped source
device.
2
HDMI OUT 1~10: Connect to HDMI TVs/displays or AV receiver for
output of video and/or audio.
3
SERVICE: This slot is reserved for manufacturer use only.
4
SYS. RESET ON/OFF: Set this switch to the ON position will allow the
device to reset the output to show the source every 10 minutes.
It will force the connected TV/display to switch to the HDMI port
that the device is connected to ensure the correct input is always
displayed. The reset will be performed sequentially from 1~10 with 1
minute a port. The default setting is OFF, leave as it is to disable the
reset function.
Note: TV/monitor must be CEC compatible for this feature to function
properly.
5
EDID STD/TV: Use this switch to set HDMI EDID’s setting.
TV
:
When in 'TV' mode, the unit will read the EDID settings of the
display device connected to HDMI OUT 1. If it detects a 4K×2K capable
EDID setting it will transmit the signal in that format to all outputs. If
no 4K×2K capable EDID is detected then the unit will output the best
resolution that all displays can support.
NOTE: When Output 1 is connected to a 4Kx2K display and Outputs 2–4 are
connected to non-4K displays no picture may be displayed. To ensure proper
display all screens must all be capable of displaying the same resolution.
STD: When in 'STD' mode, the unit will use its own built-in EDID
settings. In this mode, the video output will be set to 1080p@60Hz
and the audio output at LPCM 2CH Stereo. Use this mode if there are
display problems in TV Mode..
6
DC 5V: Connect the adaptor included in the package and connect to
AC wall outlet for power supply.
Summary of Contents for QU-110S-4K22
Page 2: ......
