CYP QU-10-4K22, Operation Manual

Page: 8 / 16

8
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Front Panel
POWER 6G
3G
IN OUT 1 OUT 2 OUT 3 OUT 4 OUT 5 OUT 6 OUT 7 OUT 8 OUT 9 OUT 10
SYNC
HDCP
EDID
STD TV
SYS-RST
ON OFF
1 2 4
3 5
6 7 8
1
POWER: This LED will illuminate when the device is connected to an
active power supply.
2 6G/3G:
When the input source bandwidth is 6G, the 6G LED will
illuminate, when input source detect as 3G, the 3G LED will illuminate.
3
IN SYNC: When an input signal is detected, the LED will illuminate.
The LED will flash when a problem with the signal is detected, for
example, when the source signal is not stable. When an input is not
connected, the LED light will remain off.
4 IN HDCP:
When an input signal with HDCP has been detected, the
LED will illuminate. The LED will flash when the is a problem with the
HDCP signal, for example when the HDCP version is not supported.
When no HDCP detected, the LED will remain off.
5
OUT 1~10 SYNC: When output signal is detected, the LED will
illuminate, the LED will flash when detected abnormal, for example,
when an output device is connected but the output sense is off. When
an output is not connected, the LED will remain off.
6 OUT1~10 HDCP:
When an input signal with HDCP has been detected,
the LED will illuminate. The LED will flash when the is a problem
with the HDCP signal, for example when the HDCP version is not
supported. When no HDCP is detected, the LED will remain off.
7
EDID: Use this switch to set the HDMI EDID setting.
TV:
When in 'TV' mode, the unit will read the EDID settings of the
display device connected to HDMI OUT 1. If it detects a 4K×2K capable
EDID setting it will transmit the signal in that format to all outputs. If
no 4K×2K capable EDID is detected then the unit will output the best
resolution that all displays can support.
NOTE: When Output 1 is connected to a 4Kx2K display and Outputs 2–10
are connected to non-4K displays no picture may be displayed. To ensure