CYP PU-8H8HBTPL-4K22, Operation Manual, Page: 9 / 24

9
6.2 Rear Panel
IR OUT
IR IN
ALL
A B C D E F G H
IR OUT
IR IN
CAT5e/6 OUT
IR OUT
IR IN
CAT5e/6 OUT
IR OUT
IR IN
CAT5e/6 OUT
IR OUT
IR IN
CAT5e/6 OUT
IR OUT
IR IN
CAT5e/6 OUT
IR OUT
IR IN
CAT5e/6 OUT
IR OUT
IR IN
CAT5e/6 OUT
IR OUT
IR IN
CAT5e/6 OUT
1
HDMI IN
2
HDMI IN
3
HDMI IN
4
HDMI IN
5
HDMI IN
6
HDMI IN
7
HDMI IN
8
HDMI IN
SERVICE
RS232
MAIN 24V
POE 24V
1 2
3 4
V+
GND
GND GND
V+
CONTROL
2 4
3
5 10 11 1 8 9
6 7
1
CONTROL: Connect to an active network for Telnet and Web GUI
control (refer to Sections 6.8 and 6.9).
Warning: Please do not connect this port directly to the PC/Laptop
as the Telnet function will not work.
2 RS-232:
Connect to a PC or control system with D-Sub 9-pin cable to
control the matrix with RS-232 commands (refer to Sections 6.6 and
6.7.
3
ALL IR OUT: Connect an IR Blaster for IR signal transmission to the
source/input location. Place the IR Blaster in direct line-of-sight of the
equipment to be controlled. It will transmit all IR signals received by
any IR extenders connected to the matrix or receivers.
4 ALL IR IN:
Connect an IR extender for IR signal reception. Ensure that
remote being used is within the direct line-of-sight of the IR extender.
IR signals received will transmitted by all IR blasters connected to the
matrix or receivers.
5
SERVICE: Manufacturer use only.
6
IR OUT 1~8: Connect to the IR blasters for IR signal transmission. Place
the IR blaster in direct line-of-sight of the equipment to be controlled.
It will transmit the IR signal received from IR extenders connected to
the matrix or receivers according to the selected input.
7 IR IN 1~8:
Connect to the IR extenders for IR signal reception. Ensure that
remote being used is within the direct line-of-sight of the IR extender.
The IR signal will be tranmitted to the selected receiver's IR OUT.
8
CAT5e/6/7 OUT 1~8: Connect from these CAT outputs to the CAT input
port of the receiver units with a single CAT5e/6/7 cable for HDMI Audio/
Video and IR/RS-232 control signal transmission.
Warning: Please do not connect the CAT5e/6/7 output into the
receiver's LAN port.