CYP PU-506-KIT, Operation Manual, Page: 8 / 16

8
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Transmitter Front and Rear Panels
Power
Link
CAT 5e /6 Out
DC 5V
IR2 Extender
RS232 In IR1 Blaster
HDMI In
Rear Front
2 3 1 5 4 6
7
8
1 RS-232 In:
Connect to a PC/laptop or RS-232 enabled device(with
supplied 3.5 mm phone jack to D-Sub 9 pin adaptor) for the
transmission of RS-232 commands.
2 IR2 Extender:
Connect to the supplied IR extender cable for IR signal
reception. Ensure that remote controller being used is within the
direct line-of-sight of the IR extender.
3 IR1 Blaster:
Connect to the supplied IR blaster cable for IR signal
transmission. Place the IR blaster in direct line-of-sight of the
equipment to be controlled.
4 HDMI In:
Connect to HDMI source equipment such as a DVD or Blu-
ray player.
5 DC 5V:
Plug the 5 V DC power supply into the unit and connect the
adaptor to an AC outlet.
6 Link:
The yellow LED will illuminate when both the input and output
CAT5e/6/7 signals are connected.
7 Power:
This green LED will illuminate when the device is connected to
a power supply.
8 CAT5e/6 Out:
Connect to the receiver unit with a single CAT5e/6/7
cable for transmission of all data signals.