CYP PU-22HC, Operation Manual

Page: 7 / 16

4
7. Operation Controls and Functions
The following sections describe the hardware components of the unit.
7.2 Front Panel
1 2 3 4 6 5
①
HDMI/CAT6 input selection: Switch to select input sources either from
HDMI or CAT6.
②
EDID Control Switcher: Default factory setting is TV, leave as if the display
is properly. Switch to STD to use built-in EDID.
[Note]:
1. When EDID switch to TV, the unit will detect the fi rst HDMI's output EDID and
record in the unit. If the fi rst detected HDMI output is DVI it will pass to next
output until the fi rst HDMI output detected.
The detection priority is HDMI v1.3 > HDMI v1.2 > DVI.
2. When EDID switch to STD the unit will use built-in EDID which supports:
Video →1080p 8-bit (max)
Audio →PCM 2CH
3. When EDID is switch to STD with input selection on HDMI or CAT6 IN the
display TV or monitor will switch to HDMI input 1, automatically. When EDID
is switch to TV regardsless of the input selection the display TV or monitor
will switch to HDMI input 1 mode. Therefore, it is not suggested to switch
the EDID to STD.
4. The EDID selection will only activate when the unit is re-plug and power on.
③
CEC output: When switch to HDMI ONLY, the HDMI output port’s CEC will
bypass the CEC commend directly to the HDMI and CAT6 input ports.
When switch to HDMI and CAT6, the HDMI and CAT6 output port’s CEC will
bypass the CEC commend cross to the HDMI .
④
HDMI Input: Connect input port to the HDMI or DVI output port of your
source equipment such as DVD player or set-top-box.
4