8
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Transmitter Front and Rear Panels
TV/STD
10 Bit
CAT6 OUT
EDID
8 Bit
12 Bit
DC 5V
HDMI INPUT
1
2
3
5
4
1
HDMI INPUT:
Connect to the HDMI or DVI output port of your source
equipment such as a DVD/Blu Ray player or Set-top box with an HDMI
cable or link up with another compatible receiver unit to extend a
signal over long distances.
2
DC 5V:
Connect the 5V DC power supply to the unit and plug the
adaptor into an AC outlet.
3
EDID Control Switch
: Switch the EDID between STD and TV modes.
Switch to STD mode to use the unit's built-in EDID settings or switch
to TV mode to use the TV/display’s EDID settings. The default factory
setting is TV, leave as is when the display is working properly.
Note: 1. When EDID is switched to STD the unit will use its built-in EDID
settings which support:
Video
→
1080p 8-bit, 10-bit or 12-bit (max)
Audio
→
PCM 2CH
2. The EDID selection will only be activated when the unit is power cycled
.
4
8/10/12-Bit Switch:
Switches between 8, 10 or 12-bit modes.
5
CAT6 OUT:
Connect the CAT6 output of the transmitter to the CAT6
input of the receiver.