CYP MOD-32, Operation Manual

Page: 15 / 32

Command Description
HPDLALL
Set the Hot-Plug-Detect of all inputs to
Low.
HPDHALL
Set the Hot-Plug-Detect of all inputs to
High.
HPDSTATUS Report the Hot-Plug-Detect signal status
of all inputs.
EDIDMODE x y
Set the EDID mode of input (x:
01~32) to (y:1~2).
EDIDMODEALL x The EDID mode of All Input to (x:1~2) .
EDIDPORT x y
Set the EDID mode of Assigned Port
(y:01~32) to Input( x:01~32).
EDIDPORTALL x
The EDID mode of All ports is assigned to
Output (x:01-32).
EDIDSTATUS Report the status of the EDID Modes of
all input ports.
UART x y "str"
Write UART string to output
port(x:in/out, y:01~32, "str":"string").
UARTBAUD x y
Set the UART Baud rate of output port
(x:01~32) (y:rate).
STATUSUART Show output port UART baud rate.
TEMPSTATUS
Show temperature sensor values y1, y2.
SETIPADDR Set the IP address (x.x.x.x).
SETSNMASK
Set the subnet mask (x.x.x.x).
SETGWADDR
Set the gateway IP address (x.x.x.x).
IPCONFIG Display the current IP configuration.
RSTIP
Reset the IP Configuration Reset To
Default values (DHCP).
BUZZER x
Mute the Buzzer (mute=0, UnMute=1).
REBOOT Reboot the System.