3
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Transmitter's Front Panel
ON
1 2 3 4
RS232
LINK PAIR
SEL
IR
IR
BLASTER
POWER
LINK
MODE
LINK
VIDEO
VGA BYPASS
4K UHD Video over IP Tx
3
1 2
4
5 6 7 8
9
1
POWER LED:
This LED will flash BLUE while the unit is powering on and
will illuminate solid BLUE once it is ready to be used.
2
LINK LED:
If the Transmitter has no network connection the LINK LED
will not illuminate. While the Transmitter is attempting to establish a
connection with a Receiver the LINK LED will flash ORANGE.
When the Transmitter has established a stable connection with a
Receiver the LINK LED will illuminate in solid ORANGE.
3
RS232 :
Connect directly to your PC/laptop to send commands
to RS-232 devices connected to the Receiver. The baud rate
is configurable, but the default baud rate is 115200. When the
Transmitter is in multicast mode every connected Receiver unit can
send RS-232 commands to the Transmitter and commands sent
from the Transmitter side will be sent to all associated Receivers.
4
IR BLASTER:
Connect to the provided IR Blaster to transmit IR signals
sent from the Receiver to devices within direct line-of-sight of the IR
Blaster.
5
IR WINDOW:
Accepts IR signals from any standard remote control
and sends the signal to the associated Receiver. When the
Transmitter is in multicast mode the IR signal is sent to all associated
Receivers.
6
LINK PAIR SEL:
These 4 dip switches determine the unit’s LINK PAIR
ID (0-15). Please check the chart at the end of this manual for the
dipswitch combination values. In unicast mode the LINK PAIR ID of
the Transmitter must be set to the same value as the destination
Receiver. In multicast mode all destination Receivers must be
set to the same ID as the multicast Transmitter. In both cases, all
Transmitters and Receivers must be connected to the same local