CYP CH-2602RX, Operation Manual, Page: 8 / 16

3
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Front Panel
TX RX L R
DC 48V
+ -
OP
T.
IN
POWER AUDIO OUT IR IN1 IR OUT2 USB USB UPDATE RS-232 OUT
CA
T5e/6/7 IN
HDMI OU
T
LA
N
OP
T.
IN
AR
C
IN
2 3 4 5 6 7 1
1 DC 48V & POWER LED: Plug the 48V DC power adapter into this
port and connect it to an AC wall outlet for power. The LED will
illuminate to indicate the unit is on and receiving power.
2
AUDIO OUT: Connect to powered speakers or an amplifier for
stereo analog audio output.
3 IR IN 1: Connect to the provided IR Extender to extend the IR
control range of remotely located devices. Ensure that the remote
being used is within direct line-of-sight of the IR Extender.
4
IR OUT 2: Connect to the provided IR Blaster to transmit IR signals to
devices within direct line-of-sight of the IR Blaster.
5
USB: Connect to USB peripheral devices such as keyboard,
mouse, printer, flash drive, etc. for connection with the USB device
connected to the Transmitter.
6
RS-232 OUT: Connect to the device you wish to control via a 3-pin
adapter cable to receive RS-232 commands from the Transmitter.
When sending commands to the Transmitter side, depending on
your equipment’s pinout, the Tx and Rx pins might need to be
reversed.
7
UPDATE: This is reserved for firmware update use only. During
normal operation the dipswitch should be set to the right.