CYP CH-1529TXPLV, Operation Manual, Page: 10 / 28

5
6.2 Rear Panel
CAT5e/6/7 OU T HQ / ST D
SWITCH
HQ
STD
HDMI IN
1 2 3 4
1 HDMI IN: Connect to HDMI source equipment such as a media
player, game console or set-top box.
2
HQ & STD LEDs: These LEDs illuminate to indicate which AVLC mode
will be used when AVLC is required. The lower green LED indicates
that AVLC will use HQ (High Quality) mode. The upper yellow LED
indicates that AVLC will use STD (Standard) mode.
3 HQ/STD SWITCH: This switch allows the user to select which
compression mode to use when AVLC is active, High Quality or
Standard.
Note: HQ (High Quality) mode uses the least amount of
compression and provides the highest possible visual quality
(perceptually identical to the original). STD (Standard Quality)
mode applies additional signal reduction methods to lower
the bandwidth requirements of 4K sources further, improving
transmission reliability over longer cable runs at the cost of some
visual fidelity.
4 CAT5e/6/7 OUT: Connect to a compatible HDBaseT Receiver with
a single Cat.5e/6/7 cable for transmission of all data signals. 48V
PoH will also be supplied when connected to a compatible PD
Receiver.
Note: The 48V PoH function is designed for powering compatible
Receiver units only. Non-PoH Receivers will need their own power
supply. Receivers from other brands may not be compatible.