3
7.
Hardware Description
The following sections describe the hardware components of the unit.
7.1 Front Panel
①
①
Power LED: The LED will illuminate in green when power on and in red
when in reset mode.
7.2 Rear panel
① ②
③
④
⑤
①
EDID switch INT/EXT:This switch allows user to select the built-in
EDID (INT) or the display's EDID (EXT).
Note: When the EDID switch is on EXT, the unit will detect OUTput 1's
display EDID and record in the unit. If the first etected OUTput 1 is
not connected, it will pass to the next which is OUTput 2...... and so on
untill the display's EDID is recoreded in the unit.
w
RESET: Press this button every time when switch the EDID allowing the
device to update the EDID selection.
e
DP OUT 1 ~ 4: These slots are where you connect the DP cable or DP to
DP cable to your DP/DP input displayer for displaying a single source on
two screens simultaneously.
r
DP IN: This slot is where you connect the DP cable from the source
equipment for signal sending.
t
DC 5V: Plug the adaptor to the AC wallout for power supply to the
device.
