CynkoMet N-221/3-3, Instructions For Use And Operation

Page: 14 / 119

Cynko Met N-221/3-3
N-221/4-3
14

Be very careful when you connect the machine.

When coupling, nobody may stay between the trailer and the tractor, it is
essential to take advantage of the adjustable drawbar support.

Coupling and uncoupling of the spreader may only take place when the
machine is immobilized with the parking brake.
3.3 Wheels

When working with the wheels, secure the spreader, in case of self-launching of
movement, using the parking brake and planting chocks under the wheels.

Replacement of wheels should be carried out on a stable ground, which prevents
collapse of the wheel on which the spreader stands or the lift.

Repair work on the wheels should be carried out in accordance with the wheel point
exchange and using appropriate tools.

After each installation of a wheel, tighten the nuts after the first 10 working hours,
then every 50 working hours to check their tightening.

The air pressure is to be checked regularly. Observe the recommended air pressure.

Dismantling the wheels can be carried out only in the case when the spreader
is not loaded.

Avoid damaged road surface, quick and variable maneuvers and high speed
during turns.

Tire valves are to be protected with caps to prevent penetration of impurities.
3.4 The pneumatic and hydraulic system

The hydraulic and pneumatic installations during operation are under high
pressure.

Regularly check the technical condition of the connections and the hydraulic
and pneumatic systems. Oil leaks and air leaks are unacceptable.

In case of failure of the hydraulic or pneumatic installation, the spreader
should be out of operation until failure removal.

When connecting the hydraulic hoses to the tractor, pay attention that the
hydraulic system of the tractor and the spreader are not under pressure. If
necessary, reduce the residual pressure system.