Cylinda FB 13002, User Manual

Page: 17 / 40

Use of baskets
The baskets can be introduced into the
appliance on the bottom of the cabinet liner
and superposed. To do so please proceed as
follows:
1. Rotate the handle 20
0
then pull the handle
in the direction shown by the arrow (item
6.1). Following this operation you get the
position of the handle as in item 6.2.
2. Rotate the handle in the direction shown by
the arrow (item 6.2) until it gets the position
in item 6.3.
3. Fasten the handle on the wire by moving it in
the direction shown by the arrow (item 6.3).
4. Thus it is obtained the assembled basket with
the handle in the shown position to be put
inside the cabinet of the appliance (item 6.4).
The baskets can be placed into the freezer as
follows (item 7).
Replacing the interior light bulb
If the lamp burns out, disconnect the
appliance from the mains. Take out the
lamp trim. Make sure the la mp is
screwed correctly. Plug in the appliance
again. If the lamp still does not go on,
replace it with another one model E14 -
15W . Mount back the lamp trim in its
place.
The lamp(s) used in this appliance is not
suitable for household room illumination. The
intended purpose of this lamp is to assist the
user to place foodstuffs in the
refrigerator/freezer in a safe and comfortable
way.
The lamps used in this appliance have to
withstand extreme physical conditions such as
temperatures below -20°C.
D ef r ost i ng of t he a pplia nc e
 We advise you to defrost the freezer at
least twice a year or when the ice layer has an
excessive thickness.

The ice build-up is a normal phenomenon.
 The quantity and the rapidity of ice build-up
depends on the ambient conditions and on the
frequency of the door opening.
 We advise you to defrost the appliance
when the quantity of frozen food is the least.

Before defrosting, adjust the thermostat
knob to a higher position so that the food
stores more cold.
- Unplug the appliance.
- Take out the frozen food, wrap it in several
sheets of paper and put them in refrigerator or
a cool place.
Take the separator panel and put it under the
freezer in the direction of the dripping tube.
Take out the obstructing plug. The water which
results will be collected in the special tray
(separator panel). After the melting of the ice
and the run-off of the water please wipe with a
cloth or with a sponge, then dry well. Put the
obstruction plug back in its place. (Item. 8)
For a fast thaw please leave the door open.
Do not use sharp metal objects to remove
the ice.
Do not use hairdriers or other electric
heating appliances for defrosting.
I nsi de cle a ni ng
Before starting the cleaning, unplug the
appliance from the mains.

It is advisable to clean the appliance when
you defrost it.

Wash the inside with lukewarm water
where you add some neutral detergent. Do
not use soap, detergent, gasoline or acetone
which can leave a strong odour.

Wipe with a wet sponge and dry with a soft
cloth.
During this operation, avoid the excess of
water, in order to prevent its entrance into the
thermal insulation of the appliance, which
would cause unpleasant odours.
Do not forget to clean also the door gasket
especially the bellow ribs, by means of a
clean cloth.
11
EN
Instruction for use