Table continued from last page
Action
Possible causes
Problem
Clean the coarse and fine filters.
The filters are blocked.
Water remains in the dishwash-
er.
Check that the filter handle is
locked in the stop position.
The filters are not fitted cor-
rectly.
Clean the drainage pump. See
the chapter Care and cleaning.
Debris in the drainage pump.
Check that the coloured stop
on the right in the bottom drain
is in place. See the chapter Care
and cleaning.
Drainage pump stop missing.
Check that the hose is free from
kinks and sharp bends.
Kink in drainage hose.
Disconnect the drainage hose
where it connects to the sink
unit's water trap. Check that no
debris has fastened and that the
connection has an inner diamet-
er of at least 14 mm.
Blocked drainage hose.
Clean with washing-up brush
and low foaming cleaner.
Dirt around the seals and in
corners.
Bad odour in dishwasher.
Run a program with a high tem-
perature once or twice a month.
Or run a self-cleaning program.
See Self-cleaning in the chapter
Using the dishwasher.
Low temperature programs
have been selected for a pro-
longed period.
Or run a self-cleaning program
once or twice a month. See
Self-cleaning in the chapter Us-
ing the dishwasher.
Low temperature programs
have been selected for a pro-
longed period.
Grease deposits in the dish-
washer.
Select a program with a high
temperature to dissolve grease
on very dirty dishes, such as In-
tensive. Or run a self-cleaning
program once or twice a month.
See Self-cleaning in the chapter
Using the dishwasher.
Fully load the dishwasher.
The dishwasher is not fully
loaded.
The dishes are not dry enough.
Top up with rinse aid or in-
crease the rinse aid dosage
level. See the chapter Settings.
Rinse aid needs topping up or
dosage is set too low.
Switch all-in-one detergents or
deactivate the setting TAB and
top up with salt and separate
rinse aid. See Rinse aid in the
chapter Settings.
The setting TAB is activated and
all-in-one detergent with insuffi-
cient drying effect is being used.
EN 71