7
Version 1.0
MENU
SUB MENU
OPERATION
uL--
u.000-u.255
Dimming
nodE
nod.0
Dimmer speed 0 (no delay)
nod.1
Dimmer speed 1
nod.2
Dimmer speed 2
nod.3
Dimmer speed 3
nod.4
Dimmer speed 4 (slowest speed)
Id
Id.01-Id.66
ID setting
tEnP
-25~100
Fixture temperature
UErn
Firmware version
rSEt
Yes/No
Reset
pnnF
(1.2~24.0)F
PWM Refresh frequency setting(KHz)
Addressing
All fixtures should be given a DMX starting address when using a DMX signal, so that the correct fixture
responds to the correct control signals. This digital starting address is the channel number from which
the fixture starts to listen to the digital control information sent out from the DMX controller. The allocation
of this starting address is achieved by setting the correct number on the display located on the base of
the device.
You can set the same starting address for all fixtures or a group of fixtures, or make different address for
each fixture individually.
If you set the same address, all the units will start to listen to the same control signal from the same
channel number. In other words, changing the settings of one channel will affect all the fixtures
simultaneously.
If you set a different address, each unit will start to listen to the channel number you have set, based on
the quantity of control channels of the unit. That means changing the settings of one channel will affect
only the selected fixture.
In the case of the FR-150C, which is 1/2/3/4 channels fixture. If you set, for example, the address in the
1 channel mode to channel 2, the device will use the channel 2 for control.
Universal DMX Control
This function allows you to use a universal DMX-512 controller to control the dimmer and strobe. A DMX
controller allows you to create unique programs tailored to your individual needs.
RDM control
The FR-150C can communicate using RDM (Remote Device Management) in accordance with ESTA’s
American National Standard E1.20-2006: Entertainment Technology RDM Remote Device Management
Over DMX512 Networks.
RDM is a bi-directional communications protocol for use in DMX512 control systems, it is the open
standard for DMX512 device configuration and status monitoring.
