11
DV160 Installation - English
SPEED SWITCH MOUNTING
MAKE SURE THAT THE SPEED SWITCH IS NOT DAMAGED. DO NOT OPERATE A DAMAGED SPEED SWITCH! DO NOT
INSTALL THE SPEED SWITCH ON AN UNEVEN SURFACE! DO NOT APPLY EXCESSIVE FORCES WHILE TIGHTENING
THE SCREWS TO AVOID THE SPEED SWITCH CASING DEFORMATION.
WARNING
•
Route all the required cables and wires to the speed switch installation place.
•
Insert the junction box from the delivery set inside the wall.
P3-1-300 mechanical speed switch mounting:
•
Connect the executive element according to the wiring diagram in page 12 and
insert it into the junction box.
•
Fasten the executive element with two screws from the delivery set.
•
Cover the executive element of the speed switch with a decorative panel and
press the latches to fix the panel.
SP3-1 sensor speed switch mounting:
•
Undo gently the switch front panel latches.
•
Remove the back panel.
•
Fix the back panel to the wall through the fastening openings.
•
Connect the control cable to the sensor speed switch following the wiring
diagram, page 12.
•
Install the front panel of the speed switch on the latches.
