Page 3 of 5
WallRack
“Angle
-
Bracket”
Installation
{Continued}
g)
Align “as shown” the
Angle Brackets #17488
with the holes and Sleeves and
insert the
Lag Screws #17505
using the T-30 Torx Driver and tighten
h)
Now align the WallRack with the end holes of the
Angle Brackets
and insert
Torx BHCS #12724
into rack top hole and run up
Serrated Flange Nut #12688
and snug, then repeat with second hole and tighten both fasteners with the T-
45 Torx Driver
and the 9/16” Hex Wrench
i)
Next offset
the bottom rack hole down by 12” vertical and over 16” center
-to-
center horizontal,
yielding approx. 48” from the rack bottom hole to the floor
j)
Repeat steps “c” thru “
h
” completing on set of racks
k)
Repeat steps “a” thru “
j
” as necessary to complete the
wall installation using a
Blue Line or Laser Level
l)
The Angle Brackets can also be used on
Drywall with Studs & Brick
, reference
Steps #1B(a-g)
for
Drywall & Studs
for Anchoring Brackets instead of
WallRacks, also
Steps #3B(a-h)
for Masonary & Brick Anchoring Brackets
instead of WallRacks and the attachment of the
Angle Brackets
&
WallRack
will
remain the same as
Steps #5B(g-j)
as above
