Cycle Torch SHARK 300, User Manual

Page: 7 / 9

SHARK 300 USER MANUAL
7
5
Switching lighting modes
OPERATION MODES
A short press of the power button will switch
through cycles & shut down the MicroBot. The
initial short press of the power button will turn
on the light on High mode. Each additional short
press of the power button switches the light
from one mode to the next, in the following order:
1 Quick flash
2 Slow flash
3 Circular flash quick
4 Circular flash slow
5 Steady
6 Off
TURNING OFF
Press & Hold of the power button will
shut down the MicroBot .
RUNNING TIME:
1,5 – 14 hours, depending on the use mode.
LOW BATTERY LEVEL
The MicroBot will automatically turn off when
the battery level is too low. This system protects
the battery from damage, but since it draws a
small amount of current, it can drain the battery
beyond the minimum voltage of the battery.
That is why the light must be turned off when
the button glows red or within 5 minutes of it
glowing red.
Do not wait until the MicroBot goes completely out as this will greatly reduce
the number of charge cycles that the battery can be used and can render the
battery unusable. It is highly recommended to recharge periodically the MicroBot .
Charge your bike light every 2-3 months when stored or not in use to prevent battery
degradation.
Operating modes:
Quick
flash
Slow
flash C.F.
quick
C.F.
slow
Steady
Run time (in hours) 6 9 10 14 1,5
Power (in lumens) 25 25 10 10 25
MICROBOT TAIL LIGHT
Operation/
Power button