Cyclades-PR4000
39
Chapter 4 - Step-by-Step Instructions
STEP TWO
No more parameters are necessary for the Ethernet interface. The other interface to be configured is the SWAN
in slot 1. The SWAN physical media parameters are shown in Figure 4.8. Fill in the values for your application.
The SWAN configuration is described in more detail in chapter 6 of the Installation Guide.
Menu CONFIG=>INTERFACE=>SWAN=>PHYSICAL
Parameter
Example
Your Application
Mode
Asynchronous
Speed
115.2k
FIGURE 4.8 SWAN PHYSICAL MENU PARAMETERS
STEP THREE
The network protocol parameters, shown in Figure 4.9, are similar to those for the Ethernet interface. Fill in the
parameters for your network in the right-most column. For an example using NAT where the Primary IP Address
is not dynamically assigned, see the chapter dedicated to NAT in the Installation Manual.
Menu CONFIG=>INTERFACE=>SWAN=>NETWORK PROTOCOL=>IP
Parameter
Example
Your Application
Active or Inactive
Active enables IP communication (IPX
and Transparent Bridge are not used in
this example).
Interface
Unnumbered/
Numbered
Numbered
Primary IP Address
0.0.0.0 (This number will be assigned
by the Access Provider dynamically.)
Subnet Mask
255.0.0.0
FIGURE 4.9 SWAN NETWORK PROTOCOL (IP) MENU PARAMETERS
