AlterPath KVM QuickStart Guide
Page 5
4.
Press Enter to disable DHCP.
5.
Enter a public IP address to assign to the KVM.
6.
Enter the domain name.
7.
Enter the IP address of the DNS (domain name)
server.
8.
Enter the IP address for the gateway.
9.
Enter the netmask for the subnetwork.
10.
To apply and save these parameter to Flash, see “To
Apply and Confirm the Network Parameters Defined
Using the wiz Command” on page 5.
!
To Apply and Confirm the Network
Parameters Defined Using the wiz
Command
This procedure must be completed immediately after
defining network parameters using the wiz command as
described in “To Use the wiz Command to Configure
Network Parameters” on page 4.
1.
Review the values of all the network configuration
parameters, as shown in the following screen
example. The values shown are for example only.
2.
Enter
y
if the values shown are correct, or press Enter
and go back to “To Use the wiz Command to
Configure Network Parameters” on page 4
to make
any desired changes.
3.
The following prompt appears when “y” is entered.
4.
Enter
y
to save the changes.
5.
To confirm the configuration, enter the
ifconfig
command.
6.
The new network parameters display.
7.
Log out from the terminal session.
8.
In a HyperTerminal application on a Windows PC, go
to “File > Exit”.
9.
If performing a first-time installation, go to “Add
Users, Configure Ports, and Add In-band Servers
Using the Web Manager” on page 7.
Configuring Basic Networking Using
the OSD
This procedure requires a hardware connection between
the KVM’s User 1 port and a local monitor, keyboard,
and mouse or a between the KVM’s User 2 port and an
AlterPath KVM RP. After the KVM and monitor are
powered on, the following OSD login screen appears.
Do you want to use DHCP to
automatically assign an IP for your
system? (y/n)[n]:
n
System IP[192.168.160.10]:
public_IP_address
Domain name[cyclades.com]:
domainname
Primary DNS Server[192.168.44.21] :
DNS_server_IP_address
Gateway IP[eth0] :
gateway_IP_address
Network Mask[#] :
netmask
Current configuration:
Hostname : kvm
DHCP : disabled
System IP : 192.168.45.32
Domain name : cyclades.com
Primary
DNS
Server
:
192.168.44.21
Gateway IP : 198.168.44.1
Network Mask : 255.255.252.0
Are all these parameters correct?
(y/n) [n] :
Are all the parameters correct? (y/
n)[n]:
y
Do you want to save your
configuration to Flash? (y/n)[n]:
y
