STEP 17-Adjusting the End of the Stroke
(Tools required–One tape measure and one 9/16” wrench.)
1. Rotate the rear pivot arm upward until the 1” diameter
protrusion is 1.25” from making contact with the frame. (See
figure 3-49.)
2. While holding the rear pivot arm in this position, adjust the
stop so that it touches the 2 x 2” tube. (See figure 3-50.)
3. Tighten the check nut to a 22 ft-lb minimum.
4. Position the foot plates at full stroke and measure the
distance from the end of the foot plate to the end of the foot
plate. (See figure 3-51.)
5. This dimension should be between 23” and 25”. If it is not
then the unit is not properly adjusted and the adjustment for
the linkage system and the adjustment for the end of the
stroke must be repeated.
Fig. 3-49
Fig. 3-50
Fig. 3-51
3 / I
NSTALLATION
23
