![background image](http://html1.mh-extra.com/html/cybex/11060/11060_owners-and-service-manual_2703619019.webp)
Cybex Eagle 11060 Seated Leg Curl Owner’s Manual
Assembly
Page 4-3
Carefully install each weight plate one at a time.
H.
NOTE: When installing weight plates, position plates so wide
edges of bushing face upward and narrow edges of bushing face downward. See Figures 6A and 6B.
Slide top weight onto guide rods.
I.
Place lower snap ring and wave washer onto guide rod (about 3” from the top end of guide rod).
J.
Raise guide rod up through mounting hole and install the upper snap ring.
K.
Lower guide rod and secure lower snap ring. Repeat steps 6J - 6L for the other guide rod.
L.
7. Belt
Routing.
Verify belt is routed through top of pulley bracket
A.
and then route end of belt down to the top weight.
Verify the belt clamp on the top weight is positioned
B.
properly with the top pulley.
NOTE:
The belt must have
a straight path from the pulley to the belt clamp.
See
Figure 7.
NOTE: Figure 7 shows the top view, looking
from the top pulley down to the top plate.
Slide belt through slot in belt clamp.
C.
Verify belt and insert are installed properly, as shown
D.
in Figure 8A.
NOTE: Do not install the insert backwards
as shown in Figure 8B.
Figure 7
Top Pulley
Increment
Weight
Adjusting
Knob
Set Screw
and Insert are
located on this
side of the belt
clamp.
Belt
Correct
belt routing
Wrong
belt routing
Figure 8A
Figure 8B
Stem
Belt
Insert
Stem
Belt
Insert
NARROW
bushing edge
WRONG
WIDE bushing
edge faces
upward
CORRECT
NOTE: The narrow bushing
edge must face downward.
Figure 6A
Figure 6B
Summary of Contents for 11060
