9. Make a slight bend in the paper edge and place bent paper edge
into the slot on the take-up spindle. Hold the paper on to the
paper spindle.
10. Push the front panel switch to the ‘Feed’ position, paper
should then wrap around the spindle. If this doesn’t, remove
paper and start at step 9 again.
11. Once the take-up is loaded, push the front panel switch to
the ‘Reprint’ (down) position. This will start a print cycle
(test print or reprint).
12. Close the front cover while the print is taking place. This
will keep the paper tight around the take-up.
Figure 2.1
