CyberResearch CPGT C2-24-X Series, User Manual, Page: 106 / 246

4.5.4.2 Floppy Drive Connector (FDD1)
This connector provides access to an externally mounted 3.5” floppy drive. To connect the
CPU Card to a FDD, follow the instructions below.
Step 1: Insert one side of the cable into the FDC making sure that the red wire on the
cable corresponds to pin 1 on the connector.
Step 2: Attach the connector on the other side of the cable to the floppy drive(s). You
can only use one connector in the set. The connection sequence determines
which of the two connected floppy drives is drive A: and which is drive B.
Step 0:
4.5.4.3 SATA Drive Connection
The CPU card has on-board SATA drive connectors. Refer to Table 1-1: for model
variations supporting two or four SATA II connectors. To connect the SATA drives to the
connectors, follow the steps below.
Step 1: Locate the SATA drive connector on the board.
Step 2: Press the clip on the connector at the end of the SATA cable and insert the
cable connector into the on-board SATA drive connector ( Figure 4-9 ).
CPGx Series CyberResearch
®
CPU Cards
84
©Copyright 2006 CyberResearch, Inc.