CyberOptics SE505, Hardware Manual

Page: 87 / 180

CyberOptics Corporation 77
Processor Components
Processor Components
Replacing Cards
Use the following procedure to replace circuit cards in the SE505 processor. Refer to Figure 57 on
page 78 for circuit card locations.
➢
General card replacement procedures
1. Turn off all electrical power to the system. For more information, refer to the section
“ Shutting Down the System ” on page 59.
2. Open the hood on the SE505.
3. Make sure all motion has stopped.
4. Remove the lower front panel by removing two screws along the top edge of the panel.
5. Remove all the cables to release the processor from the system frame.
6. Gently place the processor on the ground in front of the machine, being careful not to strain
the cable connections on the rear of the processor.
7. Remove processor cover by sliding the cover plate back toward the rear connectors.
8. Disconnect any internal cables from the card.
9. Remove the screw holding the card to the processor case.
10. Gently slide the card out of the processor case.
11. Slide the new card into the processor case, gently pushing it into place until it seats firmly in
the backplane connector.
12. Secure the card in place with the screw.
13. Reconnect cables to the card.
14. Slide the processor back into the machine frame.
Caution:
Turn the AC main circuit breaker to OFF to shut down all electrical power to the
SE505 before starting any replacement operations. For more information, refer to the section
“
Shutting Down the System ” on page 59.
Caution: The circuit cards contain components that can be damaged by static electricity. Use a
ground strap when handling circuit cards to prevent damage to sensitive components.