CyberOptics SE500ULTRA, Hardware Manual

Page: 81 / 188

CyberOptics Corporation 71
Processor Components
Processor Components
Replacing Cards
Use the following procedure to replace circuit cards in the SE500
ULTRA
processor. Refer to
Figure 41 on page 72 for circuit card locations.
➢
General card replacement procedures
1. Turn off all electrical power to the system. For more information, refer to the section
“ Shutting Down the System ” on page 52.
2. Open the hood on the SE500
ULTRA
.
3. Make sure all motion has stopped.
4. Open the swing door.
5. Remove all the cables to release the processor from the system frame.
6. Gently place the processor on the ground in front of the machine.
7. Loosen the two thumb screws on the rear of the processor.
8. Remove processor cover by sliding the cover plate back toward the rear connectors.
9. Disconnect any internal cables from the card.
10. Remove the screw holding the card to the processor case.
11. Gently slide the card out of the processor case.
12. Slide the new card into the processor case, gently pushing it into place until it seats firmly in
the backplane connector.
13. Secure the card in place with the screw.
14. Reconnect cables to the card.
15. Place the processor cover back.
16. Tighten the two thumb screws on the rear of the processor.
17. Slide the processor back into the machine frame.
18. Turn the AC power switch at the rear of the processor to ON.
Caution:
Turn the AC main circuit breaker to OFF to shut down all electrical power to the
SE500
ULTRA
before starting any replacement operations. For more information, refer to the
section “ Shutting Down the System ” on page 52.
Caution:
The circuit cards contain components that can be damaged by static electricity. Use a
ground strap when handling circuit cards to prevent damage to sensitive components.