CyberData VoIP Indoor Intercom 011030, Operation Manual

Page: 23 / 46

Installing the VoIP Indoor Intercom
Configure the Intercom Parameters
Operations Guide 930260A CyberData Corporation
15
2.3 Configure the Intercom Parameters
To configure the Intercom online, use a standard web browser.
Configure each Intercom and verify its operation before you mount it. When you are ready to mount
an Intercom, refer to
Appendix A, "Mounting the Intercom"
for instructions.
All Intercoms are initially configured with the following default IP settings:
When configuring more than one Intercom, attach the Intercoms to the network and configure one
at a time to avoid IP address conflicts.
2.3.1 Log in to the Configuration Home Page
1. Open your browser to the Intercom IP address.
For the initial configuration of the Intercom, open your browser to the default IP address:
http://192.168.3.10
Note Make sure that the PC is on the same IP network as the Intercom.
Note You may also download CyberData’s VoIP Discovery Utility program which allows you to
easily find and configure the default web address of the CyberData VoIP products.
CyberData’s VoIP Discovery Utility program is available at the following web address:
http://www.cyberdata.net/support/voip/discovery_utility.html
2. When prompted, use the following default Web Access Username and Web Access Password
to access the Home Page ( Figure 2-13 ):
Web Access Username: admin
Web Access Password: admin
Table 2-3. Factory Default Settings
Parameter Factory Default Setting
IP Addressing static
IP Address 192.168.3.10
Web Access Username admin
Web Access Password admin
Subnet Mask 255.255.255.0
Default Gateway 192.168.3.1