CyberData 011313, Operation Manual, Page: 8 / 42

1
Operations Guide 931080C CyberData Corporation
1 PoE Digital Clock Configuration Utility
1.1 Introduction
The PoE Digital Clock Configuration Utility is Windows-based software used for discovering,
configuring, and functional testing the CyberData PoE Digital Clock.
You can download the configuration utility program from the following webpage:
http://www.cyberdata.net/voip/011313/
1.2 Error Codes
There are two error codes that can be shown by the clock. These messages are displayed briefly on
the display of the clock after it has been powered.
• E 01 which means there is a memory corruption. The device should correct this when it is
synced with NTP.
• E 02 which means no battery or low battery. This means that the JP 1 has not been connected
or it could also mean that the battery is dead.
1.3 Installation
To install the configuration utility, copy the configuration utility program to the desktop or in some
other directory, and then create a shortcut for the program on your desktop or in some other
directory. See
Figure 1-1 .
Figure 1-1. Configuration Utility Program Shortcut
Note In Figure 1-1 , the configuration utility program is named CDPcUtilityR. However, the
program might be named something different on your computer.
Note Upon installation of the clock, please place the shunt over JP1. A shunt is left hanging next
to the coin cell.