© 2014, CyberData Corporation, ALL RIGHTS RESERVED
930925A
Quick Reference
Quick Reference
930925A
© 2014, CyberData Corporation, ALL RIGHTS RESERVED
Dimensions (Rear View and Mounting Holes)
Terminal Block Connections
Call Button
Features
Dimensions (Front and Side View)
Microphone
Hole
Speaker
Drain Hole
1.690
[85.85]
0.869 [22.07]
0.869 [22.07]
3.380 [85.85]
1.690
[42.93]
[42.93]
3.380
Dimensions are in Inches [Millimeter]
ø0.280 [ø7.11]
ø0.854 [ø21.69]
(4 Places)
J3 Terminal Block
Wire (IN)
can accept 16 AWG wire
*Contacts 1 and 2 on the J3 terminal block are only for
powering the Intercom from a non-PoE 12VDC power
source as an alternative to Network PoE power. Use of
these contacts for any other purpose will damage the
Intercom and void the product warranty.
Relay Contact:
(1 A at 30 VDC for continuous loads)
3 = Relay Common
4 = Relay Normally Open Contact
5 = Sense Input
6 = Sense Ground
2 = Power Ground*
1 = 8 to 12 VDC at 1000 mA*
3
4
Alternate Power Input:
7 = Reserved for Future Use
8 = Reserved for Future Use
1
8
Use a 3.17 mm (1/8-inch) flat blade
screwdriver for the terminal block screws
RTFM Button
Side Conduit Network Cable Entry Restrictions
Rear Conduit Network Cable Entry Restrictions
RTFM
When the device is operational and linked to a network,
you can use the Reset Test Function Management
(RTFM) button (SW1 [see picture]) to announce the
device’s IP address or restore the device to the factory
default settings.
To announce the device’s current IP address:
•
Press and release the RTFM button within a five
second window.
Note
The device will use DHCP to obtain the new IP
address (DHCP-assigned address or default to
10.10.10.10 if a DHCP server is not present).
To restore the device to factory default settings:
•
Press and hold the RTFM button for longer than five
seconds until you hear the device announce that it is
restoring the factory default settings.
Spacer
5/32"
(Not Provided)
1/2" Conduit
1/2" Set Screw
(Not Provided)
Connector
Assembly
Hole Plug
Network
Cable
(Not Provided)
Gap
*More installation and mounting
information is illustrated in the
Operations Guide.
1/2" Conduit
(Not Provided)
Here
Connector
1/2" Conduit
(Not Provided)
Cable
Network
Spacer
Add
(Not Provided)
Cable
Network
(Not Provided)
1/2" Conduit
1/2" Conduit
Spacer
Connector
(Not Provided)
(Not Provided)
Here
Add
With Shroud
Without Shroud
VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
