CyberData 011233, Operation Manual

Page: 50 / 98

Installing the InformaCast Enabled Paging Adapter
Restore the Factory Default Settings
Operations Guide 931767B CyberData Corporation
43
2. On the Multicast page, enter values for the parameters indicated in Table 2-10 .
Note The question mark icon ( ) in the following table shows which web page items will be defined
after the Toggle Help button is pressed
.
Note You must click on the Save button for the changes to take effect.
Table 2-10. Multicast Configuration Parameters
Web Page Item Description
Enable Multicast Operation Enables or disables multicast operation.
Priority Indicates the priority for the multicast group. Priority 9 is the
highest (emergency streams). 0 is the lowest (background
music). SIP calls are considered priority 4.5 . See Section
2.5.8.1, "Assigning Priority" for more details.
Address Enter the multicast IP Address for this multicast group (15
character limit).
Port Enter the port number for this multicast group (5 character
limit [range can be from 2000 to 65535]).
Note : The multicast ports have to be even values. The
webpage will enforce this restriction.
Name Assign a descriptive name for this multicast group (25
character limit).
Buffer Device will buffer up to four minutes of audio and then play
back the recording after the multicast stream finishes or after
the buffer is full.
Beep When selected, the device will play a beep before multicast
audio is sent.
Polycom Default Channel When a default Polycom channel/group number is selected,
the SIP Paging Adapter will subscribe to the default channel
for one-way group pages. Group Numbers 1-25 are
supported. Or, select
Disabled to disable this channel.
Polycom Priority Channel When a priority Polycom channel/group number is selected,
the SIP Paging Adapter will subscribe to the priority channel
for one-way group pages. Group Numbers 1-25 are
supported. Or, select
Disabled to disable this channel.
Polycom Emergency Channel When an emergency Polycom channel/group number is
selected, the SIP Paging Adapter will subscribe to the
default channel for one-way group pages. Group Numbers 1-
25 are supported. Or, select
Disabled to disable this
channel.
Click the Save button to save your configuration settings.
Click on the Reboot button to reboot the system.