CyberData 011233, Operation Manual

Page: 21 / 98

Installing the InformaCast Enabled Paging Adapter
Restore the Factory Default Settings
Operations Guide 931767B CyberData Corporation
14
2.5 Restore the Factory Default Settings
The InformaCast Enabled Paging Adapter is delivered with factory set default values for the
parameters in
Table 2-3 . Use the RTFM switch (see Figure 2-8 ) on the back of the unit to restore
these parameters to the factory default settings.
Figure 2-8. RTFM Switch
Note When you perform this procedure, the factory default settings are restored. The default
parameters for access are shown in
Table 2-3 .
To restore these parameters to the factory default settings:
1. Press and hold the RTFM switch until the status and paging lights come on.
2. Continue to press the switch until after the indicator lights go off, and then release it.
Note The “Restoring Defaults” announcement can be heard if a speaker or amplified speaker is
connected to the unit.
3. The InformaCast Enabled Paging Adapter settings are restored to the factory defaults.
Table 2-3. Factory Default Settings
Parameter Factory Default Setting
IP Addressing DHCP
IP Address
a
a. Default if there is not a DHCP server present.
10.10.10.10
Web Access Username admin
Web Access Password admin
Subnet Mask
a
255.0.0.0
Default Gateway
a
10.0.0.1
RTFM Switch