CWT 1736 Platinum, Assembly Manual

Page: 27 / 28

Trouble shooting user
Symtom Check Try
The desk does not run
Is the main supply connected to the
control box?
Try to connect a lamp or similar to the
main supply to check that the supply
voltage is OK.
Are all plugs mounted correctly in the
control box and the leg? See Step 4,
Electrical connection diagram.
Check all connections.
Are there any visible damages on
cables, controls, the control box or
legs?
Damaged parts must be exchanged –
connect CWT.
The desk stops and can only run in the
opposite direction
Is the desk in fully extracted position?
When the desk has reached its upper
position, it can only run downwards.
Is there much load on the desk
compared to when the desk
functioned normally?
Remove some of the load and try
again.
The desk will only run downwards
even though the desk is not
overloaded.
Perform Basic settings , see next page.
The desk does not run with full stroke
length upwards. Always stops at the
same position. The system has set a new end stop
outwards. Perform Basic settings to
remove this stop.