32
MAST SET UP AND TAKE DOWN
SEDAN AND SPORT
MAST SET UP PROCEDURE
1. Remove the two black plastic wing nuts from the mast base.
2. While supporting the mast, remove the pin in the support bar.
3. Raise the mast to its full extension and ensure that it fits correctly over the mounting studs on the roof
mounting plate.
4. Secure the stainless steel retaining bar in the appropriate rubber clip attached to the hard top.
5. Attach the two black plastic wing nuts to the mounting studs and hand tighten securely.
MAST TAKE DOWN PROCEDURE
1. Remove the two black plastic wing nuts from the mast base mounting studs.
2. Carefully lower the mast onto the stainless steel support bar and attach retaining pin.
3. Attach the black plastic wing nuts back onto the screws on the mast mounting plate and secure them
for storage by hand tightening.
4. Recommend securing the mast with a tie down.
COMMAND BRIDGE
MAST SET UP PROCEDURE
1. Remove retainer clip from bottom end of support plate.
2. Using support pole, push mast into the upright position and secure with retaining clip to fitting on solar panel
support bar.
3. Attach mast sides to port and starboard aft seat backs with retaining clips.
4. Attach port and starboard forward support arms to seat fittings with retaining clips.
MAST TAKE DOWN PROCEDURE
1. Detach port and starboard forward support arms from seat fittings.
2. Detach mast sides from port and starboard aft seat backs.
3. Release mast fittings from solar panel support bar and lower.
4. Install retainer clip on bottom end of support plate.
BRIDGE SET UP
Always transport boat with Moving Bridge in the down position resting on support blocks and secured with
provided ratchet strap. Helm seat should always be removed and stowed in main cabin.
To set Moving Bridge to upright position - remove ratchet strap - at that time the bridge should easily be lifted
into the upright position. Move stainless support legs into retention blocks and flop latch into place to secure
support legs.
To set bridge back into the transport position - disengage retention latches pull support legs aft and push bridge
down to contact support blocks - secure with ratchet strap.
Summary of Contents for C-32
Page 1: ...C 32 Owner s Manual...
Page 4: ...4 SAFETY STICKER LOCATION...
Page 38: ...38 WORKING DECK...
Page 43: ...43 NOTES...
