Cutech 40700H-CT, User Manual

Page: 15 / 31

15
ADJUSTMENTS
WARNING! MAKE CERTAIN THAT THE MACHINE IS DISCONNECTED FROM THE
POWER SOURCE BEFORE ANY ADJUSTMENTS ARE MADE.
LEVELING EXTENSION TABLES
The extension tables must be level with the planer table. To check the extension tables and
adjust if necessary:
1. Lay a straight edge (A) on the planer table (C) with one end of the straight edge over the
infeed table (B). SEE FIG 4.
2. Check to make sure that the infeed table is level with the planer table.
3. If an adjustment is necessary, raise table, loosen lock nuts (D) and adjust Hex Head Screws
(E) on each side of the table until the infeed table is level with the planer table. This will
adjust the outer edge of the table. If necessary, loosen the three screws of one side of infeed
table (F), after adjusting, then retighten the screws back. Adjust another side of infeed table
in the same manner.
4. Recheck for level and repeat adjustment if necessary.
5. Repeat this process for leveling the outfeed table.
FIG 4
A
B
C
D
E
F