Custom Works Outlaw 0720, Instruction Manual

Page: 11 / 16

- Place the cage between the front suspension
tower with the “HOOKS” slightly further forward
the the front edge of the chassis.
- Guide the “HOOKS” into the Front Cage Mount
while guiding the Short 5280 Hole Head Screws
into the Rear Bulkhead.
- Position the (2) 5274 Screws that mount the
bottom portions of the nerf bars to the Cage Half
into the holes in the Chassis.
- Lock the cage by placing 9936 Clip into the Hole
in the Head of the 5280 Screw.
CAGE INSTALLATION AND REMOVAL:
- Mount 3233 Front Bumper using 5278 Screws.
- Mount the 3421 Wing Slide Bushing to the Cage using 5254 Screws
thru the Bushing and Cage and into the 3235 Upper Cage Brace.
- Use the (2) Long 5279 Hole Head Screws mount the 3235
Upper Cage Braces onto the top of the Main Cage Halfs.
- Use the remaining (2) Short 5280 Hole Head Screws
in the back of the Main Cage Halfs.
NOTE: Do NOT tighten all the way down, leave a gap
of .100”between the screw head and cage.
- After completing the Body Panel steps, Attach
the rear of the Nerf Bar using the 5254
Screw thru the cage as shown. Attach the
front of the Nerf Bar and the Nerf Bar
Support to the bottom of the “legs” on the
Main Cage Half using 5274 Screws.
STEP #4
5278
5279
LONG
5255
3421
3233
3235
CAGE BRACE
5254
5274
5274
“HOOKS”
MAIN CAGE
5280
SHORT