Custom Equipment HY-BRID LIFTS HB-1030, Operation & Safety Manual

Page: 19 / 28

OPERATIONS & SAFETY
HB-1030/HB-1430 SUPO 610
REV M
19
SECTION 4 | TRANSPORT, HANDLING & STORAGE
4.1 | PRELIMINARY UNPACKING INSTRUCTIONS AND DEALER INSPECTION
Maintenance locks must be engaged prior to inspecting or servicing the unit when the platform is elevated. Inspect
machine for any possible damage during shipment; perform pre-delivery inspection. See checklist in the Maintenance
Manual. Reset emergency stop switches, if necessary.
4.2 | STORAGE
After periods of storage or exposure to extremes of ambient conditions (heat, cold, moisture, dust etc.) inspect the
machine. Refer to the Pre-Delivery/Frequent Inspection Checklist of the Maintenance Manual.
4.3 | PREPARATION FOR TRANSPORT
Lower the work platform to the down position. Bring the platform slide-out extension into the retracted position and
lock in place. Turn the key switch to off position. Check the entire machine for loose or unsecured items. Remove
any loose items from machine.
The machine can be pushed by releasing the parking brake at the rear of the machine. Push both levers toward the
floor. To resume normal operation, make sure both levers are up.
Do not attempt to push or tow unit with the brakes applied. Severe gear damage will occur. Towing is not recom-
mended.
To release brake for winching or pushing, rotate brake handles. Do not push at speeds more than 2 mph (0.9 m/s).
NOTE: The drive system will not function if the parking brake is in the down release position.
Brake Release
4.4 | LIFTING AND TIE-DOWN POINTS
Tie-down points are provided for securing the machine on a trailer or truck bed for transport between places of use.
They may also be used as lift points.
WARNING
DO NOT OVERLOAD BINDERS WHEN SECURING
LOAD FOR TRANSPORT