Custom Audio Electronics STIMARE STIMA-SML, User Manual

Page: 74 / 86

10.3 Alignment parameters
The “alignment point” is deined as the position inside the ticket to use for the notch alignment.
The distance between the notch edge and the alignment point is deined as “Notch Distance”.
Referring to the front of the notch, the value of “Notch Distance” value varies from -5mm minimum and 99.9mm maximum.
If the “Notch Distance” value is set to 0, the alignment point is set at the beginning of the notch.
0
-
PRINTING DIRECTION
+
Alignment
point:
notch front
Alignment
point
negative values
of “Notch Distance” positive values
of “Notch Distance”
Alignment
point
The following igure shows an example of paper with alignment point set by a positive value of “Notch Distance” (“Notch
Distance” = + A):
0
PRINTING DIRECTION
A+
Notch front Alignment point
74
CUSTOM-Powered