1. INSTALLATION AND USE
FH190SP
3
1-
After this, each time the PRINT key is pressed, the parameter is modified
and its current value is printed. Once the required value has been obtained,
press the FEED key to proceed to the next parameter, and so on. Once all
the parameters have been run through, the printing of a message signals the
end of the setting procedure.
IThe parameters affected during configuration are:
•
Emulation type (custom, EPSON, CITIZEN)
•
Print direction (normal or reverse)
•
Selection of the character dimensions (small, double width, double
height, expanded)
•
Character set
•
Enabling of the CR command
•
Enabling of transmission of CR command when the PRINT key is
pressed
•
Flow control selection
•
Selection of data bit 7 or 8 for parallel reception
•
Baudrate selection
•
Protocol selection
•
Selection of reception buffer (1KB / number of columns)
•
Enabling of Real Time Clock (optional)
•
Enabling of seconds on Real Time Clock (optional)
The settings made are saved on the EEPROM (non volatile memory).
When reset, on pressing the PRINT key the printer re-initializes.
1.3 AUTOTEST
To run the autotest, hold down the FEED key, while switching on the printer.
The autotest causes the printing of the printer’s current setting data and the
printing of the complete ASCII character set.
1.4 HEXADECIMAL DUMP
After completing the autotest procedure, the printer enters Hexadecimal
Dump mode. This function is used for the diagnostics of characters received
in serial or parallel. In fact, these are printed in hexadecimal code together
with the corresponding Ascii code.
