B
MAINTENANCE
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
43
Owner’s Guide
Wheel Installation
To reduce the possibility of component damage, do not tighten
lug nuts to more than 100 ft. lbs. (136 Nm) torque.
It is important to follow the ‘cross sequence’ pattern when installing
lug nuts to ensure even seating of the wheel against the hub.
With the valve stem to the outside, mount the wheel onto the hub with
lug nuts (1). Finger tighten the lug nuts and tighten lug nuts in a ‘cross
sequence’ pattern as shown, to a torque of 40 - 60 ft. lbs.
(54 - 81 Nm). Finally, tighten the lug nuts to torque of 80 - 100 ft. lbs.
(108 - 136 Nm).
LIGHT BULB REPLACEMENT
To reduce possibility of premature bulb failure, do
not touch new bulbs with bare fingers. Use clean,
dry tissue or paper towel to handle the glass portion
of bulb.
Locate bulb socket on backside of headlight housing and
turn bulb socket a quarter turn counterclockwise to unlock
and pull out bulb and socket. Insert new bulb and rotate
socket a quarter turn clockwise to secure.
To replace the turn signal bulb, locate bulb socket on
backside of headlight housing and turn bulb socket a
quarter turn counterclockwise to unlock and pull out bulb
and socket. Insert new bulb and rotate socket a quarter
turn clockwise to secure.
To replace the taillight bulb, roll the rubber bezel from around the edge of the tail-
light and remove lens. Install replacement bulb and replace lens.
Light bulbs are available from a local distributor, an authorized branch or the ser-
vice parts department.
FUSE REPLACEMENT
Locate the fuse block under the drivers seat. Pull out old fuse and replace with a new automotive type fuse. Fuses are
available from a local distributor, an authorized branch or the service parts department.
Valve Stem Cap
Tire style may vary
1
1
2
3
4
'Cross Sequence'
Inside of Cowl
Headlight
Casing
Screw
Headlight
Bulb
Taillight
Roll rubber bezel
away from body
