Cushman Hauler 800 Elite 2022, Owner'S Manual

Page: 55 / 68

$
33(1',;
$
$
Operating Instructions
Receptacle Display
CAUTION : Charger enclosure may be hot during charging. Use hand protection if handling the charger while charging.
­
Extension cords must be 3-wire cord no longer than 30m(100’) at 10AWG or 7.5m(25’) at 16AWG per UL guidelines.
­ Only connect ONE QuiQ charger to a single 15A circuit or the circuit may become overloaded.
Delta-Q QuiQ Charger Manual
2
www.delta-q.com
Fault Indicator ( Red Light )
­ Charger error. Refer to troubleshooting information below.
­ If solid: AC power is present.
­ If flashing: Low AC voltage. Check electrical source and cord length.
AC Indicator
Charge Indicator ( Orange Light )
­
If solid: Greater than 80% state of charge
Charge Completion Indicator ( Green Light )
­ If solid: Charging is complete
Displays scale of output current
­ If only ammeter and AC
Indicator LEDs are lit:
Less than 80% state of
charge
­ If flashing: Output has
been reduced due to
high internal charger
temperature.
Ammeter
Troubleshooting Instructions
If a fault occurs, count the number of red flashes between pauses and refer to the table below.
LED Indication
Solid Charge complete
Long flash Greater than 80% state of charge
Short flash Less than 80% state of charge
Off See charger for indications.
Flashes Cause Solution
Charger unable to apply wake-up
pulse
Refer cart to service department
Charge timeout Possible BMS error - refer cart to service department
BMS fault Refer cart to service department
Charger shutdown due to high
internal temperature. Ensure sufficient cooling airflow. Reset the charger
by interrupting AC power for 15+ seconds.
Internal charger fault
Reset the charger by interrupting AC power for 15+
seconds. Return to service department if fault persists.
Note: This is a Class A product. In a domestic environment this product may cause radio interference, in which case the
user may be required to take adequate measures.
Charger 10-LED Display
( Orange Light )
­
If off: Less than 80% state of charge or pre-charge